Battery Indicator; Charging Time And Available Recording Time - Panasonic LUMIX DMC-F1PP Operating Instructions Manual

Panasonic camcorder - camcorder/digital camera user manual
Hide thumbs Also See for LUMIX DMC-F1PP:
Table of Contents

Advertisement

KC42-PP.book 13 ページ 2002年12月19日 木曜日 午後4時36分
ª Battery indicator
The remaining battery power is displayed on the LCD Monitor. (This is not displayed
when using AC adaptor)
: The battery power is sufficient
: The remaining power is a little low
: The remaining power is low
: Recharge or replace the battery
ª Charging time and available recording time
Measured under the following conditions:
• Shooting once every 30 seconds, flash every other shot.
• Measured using supplied 16MB SD Memory Card.
• Temperature: 77 F (25°C)/Humidity: 60%
Supplied battery
The times shown in the table are approximate times. The times may vary depending
on the condition.
ª Charging environment and charging error
• Charge the battery in a place with a temperature of 50 F - 95 F (10°C - 35°C). (The battery
should also be the same temperature)
• When charging starts, the [CHARGE] indicator lights. If, after charging starts, the
[CHARGE] indicator blinks at about 1 second cycles, this indicates a charging error.
In this case, remove the AC adaptor from the electrical outlet, remove the battery and check
if both room and battery temperature is too low or high and then charge it again. If the
problem persists, consult the dealer or your nearest servicenter.
Preparation
Continuous recording/playback time
Charging time
(recordable number)
Recording with LCD monitor on
Approx. 60 min.
Approx. 90 min.
(equal to 120 still pictures)
Recording with LCD monitor off
Approx. 75 min.
(equal to 150 still pictures)
Playback time
Approx. 70 min.
13

Advertisement

Table of Contents
loading

Table of Contents