Maintenance; Storage And Transport - Toolson DWS225DC Operating Manual

Regularly check electric connections for damage. Make
sure the connection is not connected to the mains when
checking. Electric connections must comply with rele-
vant VDE and DIN stipulations. Only use connections
marked H 07 RN. Printing the type designation on the
connection is the law.
AC motor
• The power voltage has to be 230 Volt – 50 Hz.
• Extension leads up to 25 m in length must have a
cross section of 1.5 mm2, at more than 25 m length, it
has to be at least 2.5 mm2.
• The mains connection is protected against short
circuit with a 16A slow fuse.
Connections and repairs to the electrical equipment
may only be carried out by a trained electrician.
If there are any questions, please provide the following
data:
• Motor's type of power
• Data from the machine's type plate
When sending back the motor, always send the entire
motor unit with switch.
Follow the safety notices!

Maintenance

Replacing the grinding disc (Fig. 8.1, 8.2)
• Remove the sand paper (1).
• Insert the Allen key (3) into the hexagonal hole in the
centre of the grinding disc (2) and turn it clockwise to
remove the damaged grinding disc (2).
• Insert the new grinding disc (2) and tighten it again.
Replacing the carbon brushes
The carbon brushes are wear parts that wear out during
use. The carbon brushes should therefore be checked
regularly. To prevent damage to the circuit, the two car-
bon brushes must be replaced at the same time.
ATTENTION!
The carbon brushes may only be replaced by authorised
service personnel. The device must only be used with
both brushes.
Cleaning
Clean the device after each grinding process
• Regularly cleaning the device can extend its service
life and reduce the amount of repair work required.
• We recommend cleaning the connection pieces and
components of the electrical motor without water.
• The parts should be cleaned immediately after use.
• Clean the parts with a hairbrush and a dry cloth.
Service
Only have your electrical device cleaned by qualified
specialised personnel and only use spare parts with
identical designs. This ensures the technical safety
during use.

Storage and transport

1. Whenever you do not use the power tool, you must
keep it in a dry and weil ventilated place out of the
reach of children, e.g. on a high cabinet or in a
closed place.
2. Keep power tool, instruction manual and accesso-
ry parts, if any, together in the original packaging,
if possible. Thus you have all information and parts
available at any time.
3. Always hold the power tool by its handle.
4. To avoid transport damages, you must pack the po-
wer tool or use the original packaging.
5. Protect the power tool against vibrations and shock,
especially during transport in vehicles.
18 І 140