Table of Contents
Advertisement
SETUP/INITIAL Set Memory Reset
The AW-E560 has a reset function, which restores the orig-
inal settings if the wrong data is set in SETUP or INITIAL
SET.
(1) Switch camera power off, and switch it back on.
(2) Complete the operation mode/scene file setting and
press the page switch. When the new settings for
reset are displayed, press the page switch again for
about 2 seconds while "CURR: MODE 1/SCENE 1" is
displaying on the screen then the screen shown at
right on the top appears.
Note: Display message of CURR: MODE 1/SCENE 1 is
changed by selected mode and scene file for
reset.
(3) If YES is selected by pressing the Up switch within
about 10 seconds after this screen is shown, the
setup/initial set memory is reset, a message appears
as shown at right on the center, and the operation
returns to normal state.
(4) Unless NO is selected by pressing the Down switch
within about 10 seconds after the shown in Step (3)
above appears, or unless the Up switch or the Down
switch is pressed in 10 seconds or more after the
screen shown in Step (3) appears, the reset operation
is suspended as indicated by the screen at right on
the bottom and the operation returns to normal state.
RESET SETUP/INITIAL?
NOW RESET
SETUP/INITIAL MEMORY
-42-
(MODE1)
YES : UP SW
NO
: DOWN SW
NON RESET
Advertisement
Table of Contents
