Table of Contents
Advertisement
CA28T103 CONNECTION PROCEDURE
• Connecting Receiver and Control Cable CA28T103
• The control cable CA28T103 is provided with a circuit board and spacers.
• Assemble the circuit board and spacer with the receiver WV-RC100 (WV-RC150), and connect the control cable to that circuit
board.
(1) Remove the two screws on the connector board
shown from inside the receiver.
Screws
(2) Fit the two spacers on the connector board and fasten
the circuit board with the screws removed in Step (1).
Spacer
Circuit board, an accessory to the cable
-23-
Advertisement
Table of Contents
