Table of Contents
Advertisement
When the mode is set to ELC, the electronic shutter
may not function if the iris is set to AUTO in the SETUP
menu and the lens iris switch to M (manual). Make
sure that the camera and lens settings are the same. If
ELC is selected, flicker may increase under fluores-
cent lights.
4 White Balance Setting [WHITE BAL: ATW, A CH, B
CH, MANU, P SET 3.2K, P SET 5.6K]
When the mode is set to ATW, white balance is auto-
matically adjusted at all times.
When the mode is set to A CH or B CH, with SETUP
menu OFF, white balance is automatically adjusted
with the AWC switch on the back of the camera. Color
temperature conditions of two scenes can be stored in
the A CH/B CH memories. When the painting mode is
ON, fine color adjustment can be made by red/blue
gain setting of INITIAL SET menu after AWC.
When the mode is set to MANU, white balance can be
adjusted by red/blue gain setting of INITIAL SET
menu.
When the mode is set to P SET 3.2K, white balance is
adjusted to 3200K illumination.
When the mode is set to P SET 5.6K, white balance is
adjusted to 5600K illumination.
Note:
When the camera is used with an RCU (RCB), the
switch cannot be set to MANU, P SET 3.2K, or P
SET 5.6K.
5 Detail Level Setting [DTL LEVEL: OFF, LOW, HIGH]
Use this mode to select any of three detail levels as
desired: HIGH, LOW, OFF.
* Low or high level ranges can be set by using a USER
SET menu.
6 Scene File Selection Setting [SCENE FILE: 1, 2, 3,
USER A, USER B]
Mode 1:
USER A/B -- User set
SCENE
1:
SCENE
2:
SCENE
3:
Mode 2:
USER A/B -- User set
SCENE
1:
SCENE
2:
SCENE
3:
Mode 3:
USER A/B -- User set
SCENE
1:
SCENE
2:
SCENE
3:
Mode 4:
USER A/B -- User set
SCENE
1:
SCENE
2:
SCENE
3:
* USER A and B have a memory for each operation
mode (8 in total).
-35-
Advertisement
Table of Contents
