Operation Location - ADS-tec IF1100 User Manual

IF1000 series

2.2 Operation Location

This device is designed for use in industry. You must ensure compliance with the specified
environmental conditions. Using the device in non-specified environments, e.g. on board ship or in
areas containing explosive vapours, gases or gas mixes, as well as in extreme heights, is prohibited
Warning:
For the prevention of water condensate accumulation, the unit should be turned
ON only when it reaches ambient temperature. This particularly applies when the
unit is subject to extreme temperature fluctuations and/or variations.
Avoid overheating during unit operations; the unit must not be exposed to
direct sunlight or any other direct light or heat sources.
2.3 Damage Caused By Improper Use
This device must immediately be shut down and protected from any accidental commissioning if the
operating system shows any obvious damage caused by, for example, improper operating or storage
conditions, or by improper use or handling.
2.4 Warranty / Repair
During the warranty period, any repair must only be carried out by the manufacturer or by a person
authorised by the manufacturer.
© ads-tec GmbH • Heinrich-Hertz-Str. 1 • D-72622 Nürtingen
6