ADS-tec IF1100 User Manual page 28

IF1000 series
Device info
Anzeige
Device Test
Anzeige
© ads-tec GmbH • Heinrich-Hertz-Str. 1 • D-72622 Nürtingen
Selection
Device info
Selction
Screen
Keys
Alarm
Action
This option displays general device
information.
The screen shows the name of the
manufacturer, the device variant,
whether a NVRAM card is installed, the
current firmware version, and the
current firmware build.
Action
Starts the display test.
Press Enter to start the display test.
Perform this test to check the display for
correct functioning. You can visually
check whether all characters are
displayed properly on the display.
Four different test screens will appear,
each of which will need to be confirmed
by pressing any front panel key.
When the test is finished, you will
automatically be taken back to the
menu view.
Starts the key test.
Press Enter to start the key test.
Perform this test to check the keys for
correct functioning.
You will be prompted to press specific
keys, whereupon you should press the
respective key.
In case one key is defective, you may
exit the test using the other keys.
When the test is finished, you will
automatically be taken back to the
menu view.
Sets the alarm output.
Sets the alarm output and turns on the
alarm LED.
The letters AL will appear in the upper
right corner of the display, indicating
that an alarm was triggered. AL will
continue to flash until the alarm is either
switched off or acknowledged
automatically.
Perform this test to check the alarm
output for correct functioning.
27