Manual Network Adapter Configuration - ADS-tec IF1100 User Manual

IF1000 series

6.2 Manual Network adapter configuration

Note:
The notes below have been created by using Windows XP®. Should you use
a different operating system, the directory paths and properties described
here might vary.
Open the Properties tab of the network adapter you are using. The directory path is:
Start> Settings> Network connections> LAN connections> Properties.
Select the following option in the pop-up dialogue: Internet protocol (TCP/IP); then click on Properties .
Abb. 8:
Here select the following item: Use following IP address
Access to the device will only be enabled once the following parameters have been entered as the fixed
IP address, or if the computer is located in the same subnet area:
IP Address: 192.168.0.100
Note:
(The last section of digits must represent a number between 1 and 253; the value "
100" was selected in the example)
Once the IP address is entered, you have to input the Subnet mask address. If you click into the Subnet
mask box, the correct address is automatically entered.
Subnet Mask: 255.255.255.0
You can now close the dialogue boxes by pushing the "OK" button.
© ads-tec GmbH • Heinrich-Hertz-Str. 1 • D-72622 Nürtingen
37