Operation Of The Sitrans Th300; Operation With The Hart Modem And Simatic Pdm - Siemens SITRANS T4200 Operating Instructions Manual

6.3

Operation of the SITRANS TH300

6.3.1

Operation with the HART modem and SIMATIC PDM

You can both operate the transmitter and assign its parameters via the PC using the
SIMATIC PDM parameterization software and the HART modem.
Procedure for commissioning
● The HART modem must be connected to the output circuit for this purpose.
● The transmitter's power supply must be switched on.
● The load in the circuit must be at least 250 Ω; to do this, refer to the circuit diagram of the
● The parameterization software SIMATIC PDM is used for the operation.
See also
HART communication with supply via feed splitter (Page 18)
SITRANS TH200/TH300
Operating Instructions, 06/2010, A5E00393069-03
Fig. in chapter HART communication with supply via feed splitter (Page 18)
6.3 Operation of the SITRANS TH300
Operation
33