Operation Of The Sitrans Th300; Operation With The Hart Modem And Simatic Pdm - Siemens SITRANS T Series Operating Instructions Manual

Operation

6.2 Operation of the SITRANS TH300

6. Assign the output parameters
– Set the analog output:
– Set damping.
7. Transfer the modified configuration to the transmitter: click the "Download to PG/PC"
button in the toolbar.
Further information can be found on the Internet in the manual for SIPROM T
(http://support.automation.siemens.com/WW/view/en/23844748).
6.2 Operation of the SITRANS TH300
6.2.1

Operation with the HART modem and SIMATIC PDM

Requirements
In order to use or assign parameters to the transmitter, you require a PG/PC, the
SIMATIC PDM software tool, and a HART modem. Before you assign parameters to the
transmitter, the following requirements must be satisfied:
● Transmitter power supply is switched on
● The load in the circuit is at least 250 Ω.
Refer to the circuit diagram of the figure in Chapter Communication (Page 16)
● SIMATIC PDM is installed on the PG/PC and ready for operation.
Operation with SIMATIC PDM
1. Connect HART modem to the PG/PC. Refer to HART communication with supply via
isolating power supply (Page 17).
2. Connect HART modem to the transmitter output circuit.
3. Start SIMATIC PDM.
30
Specify the lower and upper limits.
Set sensor fault.
SITRANS TH200/TH300
Operating Instructions, 08/2015, A5E00393069-04