Table of Contents
Advertisement
Functional safety
7.2 Device-specific safety instructions
7.2.6
Safety characteristics
The safety characteristics necessary for using the system are listed in the "SIL declaration of
conformity". These values apply under the following conditions:
● The SITRANS TH200 / TH300 temperature transmitters are only used in applications with
● The communication is used for the following purposes only:
● The devices are operated differently:
● The safety function test has been concluded successfully.
● The transmitter is blocked against unwanted and unauthorized changes/operation.
● The following condition applies to the transmitter:
● The specified error rates apply to the typical demand of an industrial environment as in
● The calculation of error rates is based on a MTTR of 72 hours.
The maximum application time of the SITRANS TH200 or TH300 in a safety application is
20 years. Replace the device after this time.
42
a low demand rate for the safety function (low demand mode).
– Device configuration
– Reading diagnostic values
– SITRANS TH200: Operation via SIPROM T
– SITRANS TH300: Operation via SIMATIC PDM or handheld communicator
– The current signal is evaluated by a safe system.
IEC 60654-1 class C. IEC 60654-1 class C means a protected place of application, with
an average temperature of max. 40 °C for an extended period of time.
SITRANS TH200/TH300
Operating Instructions, 06/2010, A5E00393069-03
Advertisement
Table of Contents
