Table of Contents
Advertisement
Fig. 8
Programming the Control
Timer settings required—upon installation and after an extended power outage.
NOTE:
• When the transformer is plugged into the electrical outlet, 12:00 AM is flashing and PRESENT TIME show in
the upper display area. Program the timer as instructed below. If, A--- is flashing, see the Setting Model
Code section.
• A beep sounds while pressing buttons for timer programming. One beep signals a change in the timer
display. Repeated beeps means the timer will not accept a change from the button or arrow you have
pressed and you should use another.
• To program the timer, you will use the SET, UP (+) and DOWN (-) buttons.
Set present time of day
NOTE: If the words PRESENT TIME do not show in the display, press the SET button until they do.
Press the UP (+) or DOWN (-) button to set. The UP button moves the display ahead; the DOWN button moves
1
the time backward.
NOTE: Each press of a UP or DOWN button changes the time by 1 minute. Holding the buttons in changes the time
32 minutes each second.
If the present time is between noon and midnight, be sure PM show.
If the present time is between midnight and noon be sure AM shows.
When the present time shows, press SET to apply.
2
Set water hardness number
NOTE: If 15 (factory default) and HARDNESS do not show in the display, press the SET button until they do.
Press the UP (+) or DOWN (-) button to set your water hardness number in the display. The DOWN button
1
moves the display down to 1. The UP button moves the display up to 110.
NOTE: Each press of a UP (+) or DOWN (-) button changes the display by 1 between 1 and 25. Above 25, the display
changes 5 at a time ( 25, 30, 35, etc.). Holding a button in changes the numbers twice each second.
When your water hardness number shows, press SET to apply.
2
You can get the grains per gallon (gpg) hardness of your water supply from a water analysis
laboratory, or call and ask your local water department, if you are on a municipal supply or
call the GE Answer Center® 800.626.2000 to request a water hardness test kit.
RECHARGE TONIGHT
TOUCH
or
RECHARGE NOW
HOLD
Excel
TIME
SET
HARDNESS
DATA
REMAINING CAPACITY
FLOW RATE GPM
GALLONS TODAY
AVG. DAILY GALLONS
PRESENT TIME
AM
HARDNESS
9
Advertisement
Table of Contents
