Keyless Enter-N-Go - RAM 2014 5500 Owner's Manual

Keyless Enter-N-Go™

This feature allows the driver to oper-
ate the ignition switch with the push
of a button, as long as the Remote
Start/Keyless Enter-N-Go™ Key Fob
is in the passenger compartment.
Normal Starting Procedure — Keyless
Enter-N-Go™
Observe the instrument panel cluster lights when starting
the engine.
NOTE: Normal starting of either a cold or a warm
engine is obtained without pumping or pressing the
accelerator pedal
1. Always apply the parking brake.
2. Press and hold the brake pedal while pressing the
ENGINE START/STOP button once.
NOTE: A delay of the start of up to five seconds is
possible under very cold conditions. The Wait to Start
telltale will be illuminated during the pre-heat process,
When the engine Wait To Start light goes off the engine
will automatically crank.
CAUTION!
If the "Water in Fuel Indicator Light" remains on, DO
NOT START the engine before you drain the water
from the fuel filters to avoid engine damage. Refer to
"Maintenance Procedures/Draining Fuel/Water Sepa-
rator Filter" in "Maintaining Your Vehicle" for fur-
ther information.
STARTING AND OPERATING 59
4