Starting Fluids - RAM 2014 5500 Owner's Manual

206 STARTING AND OPERATING
4. If the engine is started before the "Wait To Start"
telltale turns off, the preheat cycle will turn off.
5. If the engine is cranked for more than 10 seconds, the
post-heat cycle will turn off.
NOTE:
• Engine idle speed will automatically increase to 1,000
RPM and engage the Variable Geometry Turbocharger
at low coolant temperatures to improve engine warm-
up.
• When a diesel engine is allowed to run out of fuel or
the fuel gels at low temperatures, air is pulled into the
fuel system. If your engine has run out of fuel, refer to
"Maintenance Procedures/Priming If The Engine Has
Run Out Of Fuel" in "Maintaining Your Vehicle" for
further information.
• If the engine stalls, or if the ignition switch is left ON
for more than two minutes after the "Wait To Start"
telltale goes out, reset the grid heaters by turning the
ignition switch to the OFF position for at least five
seconds and then back ON. Repeat steps 1 through 5 of
"Starting Procedure – Engine Manifold Air Tempera-
ture Below 66°F (19°C)."

Starting Fluids

WARNING!
Starting fluids or flammable liquids must never be
used in the Cummins® diesel engine (see Warning
label). Never pour diesel fuel, flammable liquid,
starting fluids (ether) into the air cleaner canister, air
intake piping, or turbocharger inlet in an attempt to
start the vehicle. This could result in a flash fire and
explosion causing serious personal injury and engine
damage.