Emergency Recording - Panasonic WJ-HD500 Operating Instructions Manual

Alarm Recording for Timer Modes
As described before, there are three recording modes for Timer Recording: Time Lapse, Multi Shot and One Shot Recording.
Two of these, Multi Shot and One Shot recording, are event-recording functions reacting to an alarm input. Therefore, there is
no difference compared to an alarm recording.
The procedure described below is an example for alarm recording in the Time Lapse Recording mode.
• Time Lapse Recording
When the Time Lapse Recording mode is selected for Timer recording, it records the alarm-activated images in this mode
with the specified recording rate, image quality and duration, as shown below.
The recording pattern varies according to the setting of the Dynamic Recording parameter (DYNAMIC REC).
(If the camera inputs 2, 4 and 5 are assigned to a group.)
• Set to GROUP
Records the group input images in sequence starting with the lower number of the video input.
• Set to ALM-ONLY
Records the particular images that have activated the alarm.
• Set to ALM-PRI
Records the alarm-activated input images preferentially over other video inputs.

Emergency Recording

The Emergency Recording is given priority over for recording images.
This recording is controlled through input from the CONTROL port on the rear of the Disk Recorder.
It records all camera images during Time Lapse Recording with the specified recording rate, quality and duration.
Refer to EMERGENCY REC SETUP menu for further details.
Emergency Recorder
80
Start
C2 C4 C5 C2
T
Thumbnail
Start
C2 C4 C5 C2
T
Thumbnail
Start
C2 C4 C5 C2
T
Thumbnail
Manual Recorder
Timer
Recorder
Emergency Recorder
Alarm 2 in
C2 C4 C5 C2
T
Thumbnail
Alarm 4 in
C2 C4 C4 C4
T
Thumbnail
Alarm 2 in
C2 C2 C2 C2
T
Thumbnail
Group 1
Group 2
Group 3
Group 4
HDD
C4 C5 C2 C4 C5
C5 C4 C2 C4 C4
T
Thumbnail
Alarm 5 in
C2 C5 C5 C5 C5
T
Thumbnail