Melsec-Fx1N Series - Omron NV3Q Connection Manual

MELSEC-FX1N Series

1-1

MELSEC-FX1N Series

PLC Model Selection
Applicable Devices
Bit/word devices
Bit devices Input relays
Output relays
Auxiliary relays
State relays
Timer contacts
Counter contacts
Word devices Input relays
Output relays
Auxiliary relays
State relays
Timer current values
16-bit counter current values
32-bit counter current values
Data registers
Communications Settings
2
Select Mitsubishi MELSEC-FX Series.
X 0000 to X 0337
Y 0000 to Y 0337
M 0000 to M 1535
S 0000 to S 0999
TS 0000 to TS 0255
CS 0000 to CS 0255
X 0000 to X 0320
Y 0000 to Y 0320
M 0000 to M 1520
S 0000 to S 0976
TN 0000 to TN 0255
CN 0000 to CN 0199
CN 0200 to CN 0255
D 0000 to D 0999
Note (1) The addressable memory ranges depend on the model of PLC that is
used. Refer to the user manuals for your PLC for details.
(2) Word device addresses in the input relay, output relay, and auxiliary relay
areas must be multiples of 16 when expressed in decimal form. (For ex-
ample: X 000, X020, X040... or M 000, M 016, M 032)
The following communications settings are recommended for the PT and
PLC.
■ PT Communications Settings (Set from the NV-Designer using the NV
Configuration.)
Item
Baud rate
Data bits
Stop bits
Parity
■
PLC Communications Settings
Set D8120 to 0. (The default value is 0, so normally nothing needs to be
done.)
No.
The decimal equivalent of the address must be a
multiple of 20.
The decimal equivalent of the address must be a
multiple of 20.
The address must be a multiple of 16.
The address must be a multiple of 16.
Setting
9,600 bps
7
1
Even
Section 1-1
Comments