Tv Screen And Video - Panasonic DMR-BCT74 Operating Instructions Manual

Troubleshooting
Troubleshooting guide

TV screen and video

Screen size is wrong.
• Check the "TV Aspect" or "Aspect for 4:3 Video".
( 90)
• Adjust the aspect ratio setting on TV.
• Adjust the aspect ratio setting on this unit.
( 100)
• If you connect to 4:3 TV, set "HDMI Video
Format" to "576p/480p". (
• Check "Aspect for Recording" before recording
or file conversion. (
The black screen appears on the TV.
• This phenomenon may occur, depending on the
TV setting, when "Quick Start" is activated.
Depending on the TV, this phenomenon may be
prevented by reconnecting to a different HDMI
input terminal.
TV reception is not displayed.
• Broadcast signals are not output from this unit's
RF OUT terminal. Select "On" in "RF OUT
( CATV Signal )". (
Picture does not appear with the HD quality
although HD setting was made.
• The pictures are output with 576p/480p
depending on the title.
The screen changes automatically.
• If "Screen Saver" is set to "On", the screen saver
function will be activated when there is no
operation for 5 minutes or more. (
There is a lot of image lag when playing video.
• Set to "0" all items in the "Noise Reduction".
( 81)
• Set "Audio Delay". (
102
SQT0351
82, 90)
82, 87)
82, 94)
89)
82, 89)
The images do not appear on the TV.
The picture is distorted during play, or video
is not played correctly.
• Check the connections. (
• Check the settings of the connected TV, etc.
• An incorrect resolution is selected in "HDMI
Video Format". ( 82, 90) Reset the setting as
follows:
1 While the unit is on, press and hold [OK], the
yellow button and the blue button at the
same time for more than 5 seconds.
• "00 RET" is displayed on the front panel
display.
2 Repeatedly press [1] (right) until "04 PRG"
is displayed on the front panel display.
3 Press and hold [OK] for at least 3 seconds.
Set the item again.
• When Dolby Digital Plus, Dolby TrueHD,
and DTS-HD audio are not output
®
properly, select "Yes" in "Default Settings"
and make proper settings. (
• The unit's TV System is different from that of the
disc. Change the TV System. (
System)
• Picture may not be seen when more than
4 devices are connected with HDMI cables.
Reduce the number of connected devices.
• The picture may be distorted or a black screen
may appear between scenes recorded with
different aspect ratios.
• Set "Deep Colour Output" (
"Contents Type Flag" (
16)
82, 95)
90, TV
82, 91) or
82, 91) to "Off".