Selecting The Remote Control Id (Remote Id); Resetting The Parental Lock Code Number (Sr Lock); Switching The Video Signal Type (Tv Format); Removing The Limitation On Hdmi Video Output (Mon.chk) - Yamaha RX-V871 Owner's Manual

Selecting the remote control ID (REMOTE ID)

REMOTE ID -ID1
Select the remote control ID of the main unit so that it matches to the ID of the remote
control (default: ID1). When using multiple Yamaha AV receivers, you can set each
remote control with a unique remote control ID for its corresponding receiver.
Settings
ID1 (default), ID2
■
Changing the remote control ID of the remote control
Perform each of the following steps within 1 minute. Otherwise, the setting will be
automatically canceled.
1
Press CODE SET on the remote control using a pointed object such as the tip of a
ballpoint pen.
2
Press SOURCE/RECEIVER.
3
Use the numeric keys to enter "5019" (ID1) or "5020" (ID2).
Once the remote control ID is registered successfully, SOURCE/RECEIVER blinks twice.
If it blinks 6 times, registration failed. Repeat from step 1.
• The registered remote control codes (p.109) are not cleared even if you change the remote control ID.

Resetting the Parental Lock code number (SR LOCK)

SIRIUS VOL.
MUTE
SRXLOCK-CANCEL
Reset the Parental Lock code number for SIRIUS Satellite Radio.
Choices
RESET Resets the Parental Lock code number.
CANCEL Does not perform a reset.
SW
PL PR
C
L R
SL SR
SBL SB SBR

Switching the video signal type (TV FORMAT)

TV FORMAT-NTSC
Switch the video signal type of this unit so that it matches to the format of your TV.
Settings
NTSC (default), PAL
Removing the limitation on HDMI video output
(MON.CHK)
MON.CHK - YES
This unit automatically detects resolutions supported by a TV connected to the HDMI
OUT jacks.
If you want to select a resolution in "Resolution" (p.98) regardless of the detection
results or if this unit does not detect it correctly, disable the monitor check function.
Settings
Enables the monitor check function. (Outputs video signals with a
YES (default)
resolution supported by the TV only.)
Disables the monitor check function. (Outputs video signals with a
SKIP
specified resolution regardless of compatibility with the TV.)
• In case this unit becomes inoperable because videos from this unit cannot be displayed on the TV after
"MON.CHK" is set to "SKIP", reset the setting to "YES.

Restoring the default settings (INIT)

INIT- CANCEL
Restores the default settings for the selected item.
Choices
VIDEO Restores the default settings for video configurations.
ALL Restores the default settings for this unit.
CANCEL Does not perform an initialization.
107
En