Setup Menu Items - Yamaha RX-V871 Owner's Manual

Setup menu items

Menu Item
Auto Setup
Power Amp Assign
Configuration
Speaker
Manual Setup
Distance
Level
Parametric EQ
Test Tone
Lipsync
Dynamic Range
Sound Max Volume
Initial Volume
Adaptive DSP Level
Analog to Analog Conversion
Video
Processing
HDMI Control
HDMI Audio Output
Standby Through
IP Address
Network Network Standby
MAC Address Filter
Function
Optimizes the speaker settings automatically (YPAO).
Selects a speaker system.
Front Selects the size of the front speakers.
Center Selects whether or not a center speaker is connected and its size.
Surround Selects whether or not surround speakers are connected and its size.
Surround Back Selects whether or not surround back speakers are connected and its size.
Front Presence Selects whether or not presence speakers are connected.
Subwoofer Selects whether or not a subwoofer is connected and its phase.
Extra Bass Sets the speakers to produce the front channel low-frequency components.
Bass Cross Over Sets the lower limit of low-frequency component produced from speakers of which the size is set to "Small".
Sets the distance between each speaker and listening position.
Adjusts the volume of each speaker.
PEQ Select Selects a type of equalizer to be used.
PEQ Data Copy Copies the parametric equalizer values acquired with "Auto Setup" to the "Manual" fields for fine adjustment.
Enables/disabled the test tone output.
Adjusts the delay between video and audio output.
Selects the dynamic range adjustment method for bitstream audio (Dolby Digital and DTS signals) playback.
Sets the maximum volume so that sound is not too loud.
Sets the initial volume for when this receiver is turned on.
Selects whether to automatically adjust the CINEMA DSP effect level in conjunction with volume adjustments.
Enables/disables the video conversion between the analog video jacks.
Enables/disables the video signal processing (resolution and aspect ratio).
Enables/disables HDMI Control. You can also configure the relevant settings (ARC, TV audio input, etc).
Selects a device to output audio.
Select whether to output videos/audio (input through HDMI jacks) to the TV when this unit is in standby mode.
Configures the network parameters (IP address, etc).
Selects whether or not to turn on this unit by the command from other network devices.
Sets the MAC address filter to limit access to this unit from other network devices.
Page
34
94
94
94
94
95
95
95
95
95
95
96
96
96
96
97
97
97
97
97
98
98
99
100
100
100
101
101
92
En