Error Messages - Yamaha YSP-2700 Owner's Manual

1 2 3 4 5 6
❑
If an error message is displayed
If an error message is displayed on the TV screen, see "Error messages" below to determine the cause and resolve the problem. Follow the instructions displayed on the TV screen
to begin measurement again.

Error messages

Error message
ERROR E-1 Please test in quieter environment.
ERROR E-2 No MIC detected. Please check MIC connection and re-try. The IntelliBeam microphone is disconnected.
ERROR E-3 Unexpected control is detected. Please re-try.
Please check MIC position. MIC should be set in front of
ERROR E-4
Sound Projector. Please re-try.
Please check MIC position. MIC should be set above 1.8m/
ERROR E-5
6.0ft and re-try.
Volume level is lower than expected. Please check MIC
ERROR E-6
position/connection and re-try.
ERROR E-7 Unexpected error happened. Please turn off and re-try.
ERROR E-9 Please check the connection with subwoofer.
Cause
There is too much noise in your listening room.
Some other operations were performed on this unit.
The IntelliBeam microphone is not placed in front of this unit.
The IntelliBeam microphone is not placed in the right distance
from this unit.
The IntelliBeam microphone cannot collect the sound
produced by this unit.
An internal system error occurred.
The subwoofer is not connected properly.
Remedy
Turn off devices, such as an air condition, that make noise, or
move the unit away from such devices.
You may want to choose certain hours during the day when
there is not much noise coming from outside.
Connect the IntelliBeam microphone to the INTELLIBEAM
MIC jack on the front of this unit and begin measurement
again.
Begin measurement again. Do not perform any other
operations with this unit during measurement.
Position the IntelliBeam microphone in front of this unit and
begin measurement again.
Position the IntelliBeam microphone at a distance of more
than 1.8 m (6 ft) from this unit and begin measurement again.
Position the IntelliBeam microphone properly, check the
connection, and then begin measurement again.
Press the z key to turn off this unit, then run AUTO SETUP
procedure again after turning this unit on.
• Be sure that the subwoofer is connected (p. 29).
• According to the subwoofer connection method (wired/
wireless), select "Subwoofer" from "Beam" and set "Bass
Out" in the setup menu, and then begin measurement
again.
PREPARATIONS ➤ f Initial settings
36
En