Table of Contents
Advertisement
Chapter 2 Preparations
(b)
Using an optional RAID controller
Jumper on motherboard (SWRAID)
Change jumper setting to 1-2 (Disabled).
(c)
Installation
For the instruction of installing the optional RAID Controller, see Chapter 2 (1.9 PCI Card).
(d)
Removal
To remove the optional RAID controller, reverse the installation procedure.
If you intend to use with the card removed, be sure to attach the blank cover attached to the riser card.
Note
When installing an optional RAID Controller, start the BIOS Setup utility, select PCI
Configuration from the Advanced menu, and then make sure that the parameter
of PCI Slot xx ROM (xx is PCI slot number) is set to Enabled.
Important
Do not change the mode to hibernate when building a RAID system.
Important
When connecting a RAID controller, set the boot priority to 8th or higher in
the Boot menu of the BIOS Setup utility. If the setting is 9th or lower, the
configuration menu for RAID controllers cannot be launched.
Express5800/T110h-S User's Guide
1. Installing Internal Optional Devices
43
Advertisement
Table of Contents
