Vac Assembly - RIDGID RV34100 Owner's Manual

SP6906 RIDGID ESF.qxp_SP6636 12/10/14 9:27 AM Page 7

Vac Assembly

1. Position the powerhead assembly on
the drum as shown,
2. Hook the latches over the tabs on the
powerhead assembly.
3. Press the latches down until they
snap closed against the sides of the
tank.
Insert Hose
Insert the push button end of the locking
hose into the inlet of the Vac. The hose
should snap into place.
To remove the hose from the Vac, press
the release button in the hose assembly
and pull the hose out of the Vac inlet,
as shown.
7
Powerhead
Assembly
Tab (2)
Latch (2)
Press Then
Push or Pull
Vac Inlet
Release
Button