Shimano STEPS E8000 Series User Manual page 58

Symptom
The gear position is not
displayed.
Can the beep be turned off.
SC-E6010
Can the backlight be turned
off.
The setting menu cannot be
launched while riding the
bicycle.
Other
Symptom
When pressing the switch,
two beeps sound, and the
switch cannot be operated.
Three beeps sound.
When using an electronic
gear shifting, I feel that the
level of assistance weakens
when the gears shift.
Sound occurs after gear
shifting.
A noise can be heard from
the rear wheel during
normal riding.
When you stop the bicycle,
the gear does not shift to
the position preset in the
start mode.
Cause / Possibility
The gear position is only displayed when
using the electronic gear shifting unit.
The product is designed so that if it detects
that the bicycle is being ridden, the setting
menu cannot be launched. This is not a sign
of an abnormality.
Cause / Possibility
Operation of the switch being pressed has
been disabled.
An error or warning is occurring.
This occurs because the level of assistance is
being adjusted to the optimum level by
computer.
Gear shifting adjustment may not have
been carried out correctly.
You may have been pressing the pedals too
strongly.
Check if the electric wire connector is
disconnected. If you are not sure, contact
the place of purchase.
Change the setting.
Refer to "Beep".
Change the setting.
Refer to "Backlight".
Stop the bicycle and then make the
settings.
It is not a sign of a malfunction.
This occurs when a warning or error is
displayed on the cycle computer. Refer to
the section "Error messages on the cycle
computer" and follow the instructions
provided for the appropriate code.
It is not a sign of a malfunction.
Contact the place of purchase.
For mechanical gear shifting
Adjust the cable tension. For details, refer
to the Service Instructions for the derailleur.
For electronic gear shifting
Contact the place of purchase.
If you press the pedals lightly, the gear
shifts more easily.
56
Remedy
Remedy