Shimano STEPS E8000 Series User Manual page 27

4.
To cancel [WALK] mode, release Y1 and press X1.
• When [WALK] mode is canceled, the mode active
before [WALK] mode was set, is re-activated.
SW-E8000-L/SC-E8000
X1
• If Y1 is not pressed for one minute or more, the mode active
before [WALK] mode was set, is re-activated.
• If the bicycle is not moved after [WALK] mode is activated,
walk assist is automatically inactivated. To re-activate
[WALK] mode, momentarily release Y1 and then hold down
Y1.
• The walk assist function can operate at a maximum of 6
km/h.
• The assistance level and speed vary with the gear position.
• The intelligent walk assist function activates when an
electric shifting system such as XTR, DEORE XT SEIS is
connected.
System individually supplies assist power to detect gear
position.
"Intelligent walk assist" support rider more torque output in
steep climb condition in lower side gears.
"Quick walk assist" function works quickly by holding down
SW from any mode.
SW-E6000/SC-E6010
X1
25