Drive Unit Setting Data Backup Function; Connection And Communication With Devices - Shimano STEPS E8000 Series User Manual

Drive unit setting data backup function

The data saved to the drive unit is usually backed up automatically. However, performing the following operations will cause
a message to appear asking whether or not to update the backup data.
• Reinstalling the cycle computer on a bicycle with different settings.
• Changing the drive unit settings via E-TUBE PROJECT.

Connection and communication with devices

The system can be configured and firmware can be updated when the bicycle is connected to a device.
You need E-TUBE PROJECT to configure SHIMANO STEPS and update firmware.
Download E-TUBE PROJECT from the support website (http://e-tubeproject.shimano.com).
For information on how to install E-TUBE PROJECT, check the support website.
Connecting to devices is not possible while charging.
• You need SM-PCE1 and SM-JC40 / JC41 to connect SHIMANO STEPS to a PC.
• Firmware is subject to change without notice.
If necessary, contact the place of purchase.
NOTE
47