Control Features - GE GHDS830EDWS Technical Service Manual

Hide thumbs Also See for GHDS830EDWS:
Table of Contents

Advertisement

Throughout this manual, features and appearance may vary from your model.
Controls
B
A
Power
A
Press to "wake up" the display. If the display is active, press to put the dryer into idle mode.
NOTE: Pressing Power does not disconnect the appliance from the power supply.
Start and Pause
B
Press Start to begin the cycle. NOTE: The door must be closed for the dryer to start the cycle. Pressing Pause will pause the
cycle, the Start will blink and "PAUSE" will scroll across the LCD.
To continue the cycle, press Start again. To stop the cycle, hold the button for 3 seconds.
Display and Status Lights
C
The display shows the approximate time remaining until the end of the cycle.
In addition, this display will, "scroll" the dryer status:
PAUSE
The message "PAUSE" will scroll across the display when the dryer's cycle is paused. The cycle may be
re-started by pressing the Start button.
door
The message "door" will be displayed when the door is opened during the dryer's cycle.
CyCLE
The message "CyCLE" will be displayed when the clothes are dry and the washer is recommending a
preferred cycle for the next load (see CleanSpeak section).
dELAY
The message "dELAY" will be displayed when the Delayed Dry is initiated. It will be replaced with the
estimated time when cycle starts.
ES
Dryer in a delay start (4 hour maximum) awaiting lower energy rates (see About Appliance
Communication - Energy Smart section).
Cycle status lights
Shows whether the washer is in the DRYING, DAMP, or COOL DOWN cycle.
Feature status lights indicate:
The My Settings feature is on for this cycle.
The dryer is locked - will blink once if you press any button or turn the cycle knob.
The signal is on. See the Variable Signal description.
The Energy Smart feature is selected. See About Appliance Communication - Energy Smart section.
The Clean Lint Filter light will stay on for 15 seconds after the cycle stops.
The eDry feature is selected.
A Delay Dry time is set.

Control Features

D
Sanitized
Normal
Mixed Loads
Cottons
Jeans
Casuals
Towels / Sheets
Permanent Press
Bulky Items
Quick Dry
Quick Fluff
No Heat
Timed Dry
STEAMselect
Select Steam Cycle and PUSH "STEAMselect" for garment amount
1 to 2
3 to 5
6 to 7
8 to13
C
90 ~ 99
70 ~ 80
Active Wear
ESTIMATED TOTAL CYCLE TIME
DRYING
50 ~ 60
CLEAN
LINT FILTER
DAMP
Delicates
30 ~ 40
COOL
DOWN
DELAY
Energy Smart
DRY
10 ~ 20
Steam Refresh
Time
Steam Dewrinkle
Delay
Extended
Dry
Tumble
Hold 3 seconds
to CANCEL
Dry
E F
– 6 –
G
Drum
Extra Dry
High
More Dry
Medium
Dry
Low
Less Dry
Extra Low
Damp
No Heat
Level
Temp
Damp
Rack
Use Timed Dry
Alert
Dry
Cycles Only
Good
Best
e
monitor
H
(Continued next page)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents