Inlet and Outlet Thermistors
Disconnect power from the dryer. Check from the J10 connector on the board. Set your meter to resistance
setting.
Inlet thermistor: Check resistance between the 2 WHITE wires.
Inlet control thermistor approximate resistance values:
59.4 - 65.7K at 69°F (20°C)
•
47.6 - 52.4K at 77°F (25°C)
•
38.4 - 42K at 86°F (30°C)
•
Outlet thermistor: Check resistance between the 2 BLUE wires.
Outlet control thermistor approximate resistance values:
118 - 122K at 69°F (20°C)
•
98 - 102K at 77°F (25°C)
•
78 - 82K at 86°F (30°C)
•
CHASSIS
BASE
INLET CONTROL
THERMISTOR
Note 1: This wire marked as Y (yellow) might be W (white) in some units.
UPPER ROD
LOWER ROD
DSM
1
MODULE
OUTLET
CONTROL
THERMISTOR
POWER BOARD
J25
J11
J10
1
1
1
S-20
GY-20
P-20
R-20
B-20
O-20
N-20
GY-20
Y-20
SEE NOTE 1
3
Y-20
SEE NOTE 1
N-20
N-20
– 42 –
(Continued Next Page)