Realignment - Kenwood TK-7102H Service Manual

TK-7102H
1. Modes
User mode
PC mode
Clone mode
Mode
User mode For normal use.
PC mode Used for communication between the
radio and PC (IBM compatible).
Data programming
mode and other features to and from the radio.
PC test mode Used to check the radio using the PC.
This feature is included in the FPU.
PC tuning mode Used to tune the radio using the PC.
Clone mode Used to transfer programming data from
one radio to another.
2. How to Enter Each Mode
Mode
User mode
PC mode Received commands from PC
Clone mode [1]+Power ON (Two seconds)
3. PC Mode
3-1. Preface
The TK-7102H transceiver is programmed using a per-
sonal computer, a programming interface (KPG-46) and pro-
gramming software (KPG-70D).
The programming software can be used with an IBM PC
or compatible. Figure 1 shows the setup of an IBM PC for
programming.
8

REALIGNMENT

Data program-
ming mode
PC test mode PC tuning mode
Function
Used to read and write frequency data
Operation
Power ON
3-2. Connection Procedure
1. Connect the TK-7102H to the personal computer with the
interface cable.
2. When the Power is switched on, user mode can be en-
tered immediately. When the PC sends a command, the
radio enters PC mode.
When data is transmitted from transceiver, the red LED
blink.
When data is received by the transceiver, the green LED
blink.
In the PC mode, 4CH LEDs, [MON] LED and [●] LED are
turned on.
Notes :
• The data stored in the personal computer must match
model type when it is written into the EEPROM.
• Attach the interface cable, then change the TK-7102H to
PC mode.
3-3. KPG-46 Description
(PC programming interface cable : Option)
The KPG-46 is required to interface the TK-7102H to the
computer. It has a circuit in its D-subconnector (25-pin) case
that converts the RS-232C logic level to the TTL level.
The KPG-46 connects the modular microphone jack of the
TK-7102H to the computers RS-232C serial port.
IMC-PC
KPG-70D
Fig. 1
3-4. Programming Software Description
The KPG-70D programming disk is supplied in 3-1/2" disk
format. The software on this disk allows a user to program
TK-7102H radio via a programming interface cable (KPG-46).
3-5. Programming With IBM PC
If data is transferred to the transceiver from an IBM PC
with the KPG-70D, the destination data (basic radio informa-
tion) for each set can be modified.
KPG-46
TK-7102H