Replacement Of Universal Joint Spider - Daihatsu F300 Service Manual

PROPELLER SHAFTS
2. Install the propeller shaft with the mating marks that were
put during the removal of the propeller shaft aligned with
each other.
Tightening Torque:
58.8 - 78.5 N·m (6.0 - 8.0 kgf-m)
CAUTION:
• Make sure to line up those mating marks
that
were put
during the removal of the front propeller shaft. If this
caution should fail to
be
observed, the propeller shaft
may emit abnormal noise or vibration.
REPLACEMENT OF UNIVERSAL JOINT SPIDER
SUBASSEMBLY(FRONn
1. Move the center of the propeller shaft in up-&-down and
right-&-left directions so as to check the universal joint
spider for excessive play by hand feeling.
NOTE:
• The removal procedure for the universal joint spider
subassembly is the same both at the sleeve yoke side
and at the flange yoke side. Therefore, the procedure for
the sleeve yoke (at the differential side} only is described
here.
2. Remove the front propeller shaft by removing the four bolts.
CAUTION:
• Prior to the removal, mating marks should be put on
each of the flange yoke and companion flange of the
front differential.
• If this operation should fail to be pertormed, the propeller
shaft may emit abnormal noise or vibration during the
running.
3. Put different paint mating marks on the propeller shaft and
each of the yoke side sections (universal joint sleeve yoke
subassembly and universal joint with flange yoke). (The
illustration in the right figure indicates an example of mating
marks.)
CAUTION:
• If this operation should fail to be performed, the propeller
shaft may emit abnormal noise or vibration during the
running.
PR-6
•
•
Universal joint with flange yoke side
•
Universal joint sleeve yoke side
•