Daihatsu F300 Service Manual page 239

TRANSMISSION
&
TRANSFER
21. Install the transfer output shaft space No. 2 (A) and transfer
front drive gear bearing inner race (B) to the transfer output
rear shaft.
22. Apply the gear oil to the outer periphery of the transfer front
drive gear bearing inner race and needle roller bearing.
23. Install the needle roller bearing to the transfer output rear
shaft.
24. Install the transfer front drive gear sleeve, transfer front
drive shift fork and transfer front drive shift fork shaft in a
set.
CAUTION:
Use the new two
~E"
rings.
NOTE:
• The transfer front drive gear sleeve should be installed
in the correct direction as indicated in the right figure.
Be sure to install the sleeve in such a direction that the
gear chamfered section (A) as indicated in the right
figure, comes at the front side (transmission case side).
25. Install the ball and compression spring to the transfer front
case in this sequence.
TR-50
•
•
•
(A)
•