Table of Contents
Advertisement
CFM Mep Settings
This window is used to display the CFM, maintenance intermediate point and continuity check message on the Switch.
To view this window, click Switch Configuration > CFM > CFM Mep Settings as shown below:
CFM Remote Mep
This window is used to configure the CFM settings on the Switch.
To view this window, click Switch Configuration > CFM > CFM Remote Mep as shown below:
The following parameters can be set or are displayed:
Parameter
Description
CFM State
Used to Enable or Disable the CFM State.
MD
Enter the maintenance domain name you wish to create.
Level
Enter the maintenance domain level.
MD
Enter the maintenance domain name you wish to configure.
MIP
This setting controls the creation of MIPs.
None – Means that no MIPs will be created. This is the default value.
Auto – MIPs are created when the next lower active MD-level on the port is reached or there are
no lower active MD levels.
Explicit – MIPs are created when the next lower active MD-level on the port is reached.
SenderID TLV
Used to define the TLV data types of the maintenance domain. The user can choose between
None, Chassis, Manage or Chassis Manage.
To create a new entry enter the appropriate information and click Add. To configure the settings enter the appropriate
information and click Apply.
DAS-3626 VDSL2 Switch User Manual
Figure 52. CFM Mep Settings menu
Figure 53. CFM Remote Mep menu
Connectivity Fault Management Create(MD)
Connectivity Fault Management Settings(MD)
50
Hide quick links:
Advertisement
Table of Contents
