Ssb (V2 - Philips JL2.1E Service Manual

EN 12 4. JL2.1E AA
4.3.5 Top Control
1. Disconnect all cables from the panel.
2. Remove all mounting screws from the panel.
3. Release the clamps and take out the panel.
4.3.6 Stand-by Supply / Audio Amplifier Panel
1. Disconnect all cables from the panel.
2. Remove all mounting screws from the panel.
3. Take out the panel (it hinges at the bottom side).
4.3.7 DC/DC Interface Panel (only for 32" model)
1. Disconnect all cables from the panel.
2. Release the clamps and take out the panel.
4.3.8 Main Supply Panel
1. Disconnect all cables from the panel.
2. Remove all mounting screws from the panel.
3. Take out the panel (it hinges at the right side).
4.3.9 SSB
1
2
Figure 4-13 LVDS connector locking bracket
Figure 4-14 SSB top shielding screws
Mechanical Instructions
1
F_15490_017.eps
240605
1
2
E_14620_030.eps
130504
4
Figure 4-15 SSB top shielding
6
5
Figure 4-16 Connector plate
9
8
For
PDP
Figure 4-17 SSB brackets
1. 1st Figure: Remove the LVDS connector locking bracket
[1], [2].
2. 2nd Figure: Remove all shielding fixing screws [2].
3. 3rd Figure: Slide, and lift the shielding at the top [3] (Note:
in some cases a piece of tape is used at the left underside
of the SSB. This tape must be cut or removed before you
can lift the shielding). The panel hinges at the SCART side.
3
F_15490_015.eps
230605
7
F_15710_144.eps
200905
F_15490_027.eps
240605