Philips JL2.1E Service Manual page 11

1. Disconnect all connectors (3) from the Ambient Light
inverter panels.
2. Remove all screws (4) around the edges of the rear cover.
3. Remove all screws (5) from the rear cover.
4. Lift the rear cover from the set. Make sure that wires and
flat foils are not damaged during the removal.
4.3.3 NXT Speakers
1
E_14620_033.eps
130504
Figure 4-8 Speaker mounting screws at the rear side
2
Figure 4-9 Front cover removal
E_14620_035.eps
Figure 4-10 Speaker mounting screws at the front side
Mechanical Instructions
2
E_14620_034.eps
130504
3
090704
JL2.1E AA
Figure 4-11 Speaker removal
1. Remove all speakers mounting screws [1] at the rear side
of the set (one screw is located under the Card reader /
Side I/O).
2. Flip the set over (be aware that the front cover is loose
now), and remover the front cover [2].
3. Remove all speakers mounting screws [3] at the LCD side.
4. Release the speaker cable from its fixations
5. Take out the speaker unit [4].
4.3.4 Ambient Light Inverter Panel(s)
These models are equipped with two AmbiLight Inverters.
1. Disconnect all cables at the Inverter panels.
2. Remove all mounting screws from the panels.
– For the 32" model, the panels are mounted on the
metal frame. It might be necessary to remove the
mounting bars first as they cover these screws partly.
– For the 37" and 42" models, the panels are mounted
inside the rear cover.
3. Take out the panel.
Figure 4-12 Ambilight inverter panels (37" and 42")
4. EN 11
4
E_14620_036.eps
130504
F_15710_149.eps
200905