First Time Installation; Program Manage Settings - Megasat HD 510 User Manual

5 First Time Installation

After all connections have been made properly, switch on TV and
make sure the receiver is connected to the Main Power. Press
Power button to switch receiver on. If you are using the receiver
for the first time or restored to Factory Default, the Main Menu will
appear on your TV screen.
(1) Select [OSD Language] and press
select the desired language.
(2) Select [Satellite Setup] and press
Satellite Setup menu.
(3) Select the desired satellites by using the
and press OK to confirm.
Press / key to switch to the satellite settings and use the
Use the / key to change the settings.
Note:
If you are using more than one Satellite you need to assign the satellites the correct
DiSEqC-LNB that is used in your satellite installation.
(4) Press the BLUE button to proceed.
(5) Select how to search and which channels should be stored.
Select the Scan Mode. Normally Standard is the best choice.
Select the channels to be stored. For this device only free available channels can be stored.
Select if all or only TV or Radio channels should be stored.
(6) Press the BLUE button to start the scan process.
(7) Once channel tuning is complete, you are now ready to watch TV.
5.1

Program Manage Settings

To access the Menu, press the MENU button and select [Program].The Menu provides options to adjust
the Program Manage Settings. Select an option and press OK or
button to exit the Menu.
8
/ key to
/ /OK to
/ -Keys
to adjust that setting. Press the EXIT
/ -keys to select.