Advertisement
the clip of the battery cable onto the
buttons of the battery bracket and insert
this in the battery compartment. Close the
lid again and engage the lock – that's it.
Mains operation (seca 782 / 783 )
The scale is powered by a mains unit. The
connection socket for the mains unit is in
the base of the scale.
You must check before connecting the
equipment whether the AC voltage
given on the mains unit matches the
local mains voltage given on your
electricity meter.
• Carefully tilt the scale to one side so that
the base of the scale is accessible.
• Plug the latching plug of the mains unit
into the connection socket in the base of
the scale.
• Stand the scale back up again.
• Connect the mains unit to a power
socket.
• If the digital display now comes on,
switch off the scale using the START
key.
10
Visit www.balances.com Your Authorized Seca Dealer
How to weigh properly ...
Start scales and set to zero
Press the green Start button: the display
first shows
display for 1 sec., then automatically
The scales are now ready to use. If when
unladen the scales should not show
exactly
, they can be re-set to
switching off and back on again using the
green Start key.
To switch off the scales, simply press the
Start key.
Weighing
Is the display on zero? Then you can start!
Simply stand on the scales and keep still.
The display now shows your weight.
Switching between kg/lbs/sts
If you want weight displayed in a unit other
than the one displayed, then press the kg/
lbs switch on the display surface after
switching the scales on or during
weighing. The unit selected is shown by
the indicator "kg", "lbs" or "sts" on the right-
hand side of the display.
In order to display stones, you must keep
the key for switching between kg/lbs/sts
depressed for at least 2 seconds.
Pressing the key briefly takes you back to a
kg display. Holding it down for a long time
(at least 2 seconds) switches you between
lbs and sts.
The scales always start with the unit they
were displaying when switched off.
for 1 sec., then the full
, but for example
or
by
.
Automatic
switch-off/economy mode
The scale automatically detects whether it
is being operated on rechargeable
batteries alone or whether it is connected
to the mains.
With rechargeable battery operation:
automatic shut-down after 30 seconds.
With mains operation: shut-down only
via keypad.
Temperature changes
If the scales are exposed to a severe
change in temperature either before or
during use, then to avoid small
measurement errors, you should wait 15
minutes for the scales to adapt to the new
temperature. A flashing display indicates
that the scales are being operated during
temperature changes which are too
severe.
kg/lbs/sts
Advertisement
