Changing The Programme After It Has Started; Child-Proof Lock - Beko DCSC 821 W Installation & Opersting Instructions

Selecting a Programme and Operating Your Machine
6.13 Changing the programme after it
has started
You can use this feature to dry your clothes under higher
or lower temperatures after your dryer has started.
For example;
• Press and hold the "Start/Pause/Cancel" button
for about 3 seconds to "Cancel" the programme in
order to select "Extra Dry" programme instead of
"Iron Dry" programme.
• Select the "Extra Dry" programme by rotating the
programme selection button.
• Press "Start/Pause/Cancel" button to start the
programme.
C
Press "Start/Pause/Cancel" button for 3
seconds to cancel the programme or turn
the programme selection knob in any
direction to end the programme while the
machine is running. Water tank and filter
cleaning warning lights turn on to warn the
user when the programme is cancelled by
pressing the "Start/Pause/Cancel" button
for 3 seconds. However, the warning
lights do not turn on when the programme
is cancelled by turning the programme
selection knob. Only the drying light turns
on and the machine remains in hold until
a new programme is selected and the
"Start/Pause/Cancel" button is pressed.
Child-proof lock of the machine should not
be active in order to perform these two
operations. If the child-proof lock is active,
deactivate it before performing these
operations.
Adding/removing laundry in standby mode
In order to add or remove laundry after the programme
starts:
• Press the "Start/Pause/Cancel" button to switch the
dryer to "Pause" mode. Drying process will stop.
• Open the door at "Pause" position and close it again
after adding or taking out laundry.
• Press "Start/Pause/Cancel" button to start the
programme.
24 /32 EN
Any laundry added after the drying process
C
has started may cause the dried clothes in
the machine intermingle with wet clothes
and the result will be wet laundry after the
drying process is over.
Laundry may be added or taken out
as much as desired during a drying
process, but this process will extend the
C
programme duration and increase energy
consumption since the drying will be
interrupted continuously. Therefore, it is
recommended to add laundry before the
drying programme has started.

6.14 Child-proof lock

There is a child-proof lock to prevent any programme
interruption due to the pressing of button while the
programme is running. The loading door and all buttons
except the "On/Off" button on the control panel are
deactivated when the child-proof lock is active.
Press the "Start/Pause/Cancel" and "Cancel audio
warning" buttons simultaneously for 3 seconds to
activate the child-press lock.
To start a new programme after the programme is over
or to interrupt the programme, the child-proof lock
should be deactivated. Press the same buttons for 3
sec. again to deactivate the child-proof lock.
C
Child-proof lock is deactivated when the
machine is restarted by pressing the On/
Off button.
Start/
Pause
Cancel Press
& Hold 3 sec.
Dryer / User Manual