Changing The Programme After It Has Started; Child-Proof Lock - Beko DRVS 73 W User Manual

C
If more than one LED light up
or flash concurrently, it means
there is malfunctioning or a
failure (please see, Solution
suggestions for problems).
6.12 Changing the programme
after it has started
You can use this feature to dry your clothes
under higher or lower temperatures after
your dryer has started.
For example;
1. Press and hold the "Start/Pause/Cancel"
button for about 3 seconds to "Cancel"
the programme in order to select "Extra
Dry" programme instead of "Iron Dry"
programme.
2. Select the "Extra Dry" programme by
rotating the programme selection button.
3. Press "Start/Pause/Cancel" button to
start the programme.
C
Press "Start/Pause/Cancel"
button for 3 seconds to cancel
the programme or turn the
programme selection knob in any
direction to end the programme
while the machine is running.
Water tank and filter cleaning
warning lights turn on to warn
the user when the programme
is cancelled by pressing the
"Start/Pause/Cancel" button for
3 seconds. However, the warning
lights do not turn on when
the programme is cancelled by
turning the programme selection
knob. Only the drying light turns
on and the machine remains in
hold until a new programme is
selected and the "Start/Pause/
Cancel" button is pressed.
Child-proof lock of the machine
should not be active in order to
perform these two operations.
If the child-proof lock is active,
deactivate it before performing
these operations.
Dryer / User Manual
Adding/removing laundry in standby
mode
In order to add or remove laundry after the
programme starts:
1. Press the "Start/Pause/Cancel" button to
switch the dryer to "Pause" mode. Drying
process will stop.
2. Open the door at "Pause" position and
close it again after adding or taking out
laundry.
3. Press "Start/Pause/Cancel" button to
start the programme.
C
Any laundry added after the
drying process has started may
cause the dried clothes in the
machine intermingle with wet
clothes and the result will be wet
laundry after the drying process
is over.
C
Laundry may be added or taken
out as much as desired during a
drying process, but this process
will extend the programme
duration and increase energy
consumption since the drying
will be interrupted continuously.
Therefore, it is recommended to
add laundry before the drying
programme has started.

6.13 Child-proof lock

There is a child-proof lock to prevent any
programme interruption due to the pressing
of button while the programme is running.
The loading door and all buttons except the
"On/Off" button on the control panel are
deactivated when the child-proof lock is
active.
Press the "Start/Pause/Cancel" and "Cancel
audio warning" buttons simultaneously for 3
seconds to activate the child-press lock.
To start a new programme after the
programme is over or to interrupt the
programme, the child-proof lock should be
deactivated. Press the same buttons for 3
sec. again to deactivate the child-proof lock.
25 / EN