Changing The Programme After It Has Started; Child-Proof Lock - Beko DSC85W Installation & Operating Instructions Manual

Changing the programme after it has
started
You can use this feature to dry your clothes under
higher or lower temperatures after your dryer has
started.
For example;
1. Press and hold the "Start/Pause/Cancel"
button for about 3 seconds to "Cancel" the
programme in order to select "Extra Dry"
programme instead of "Iron Dry" programme.
2. Select the "Extra Dry" programme by rotating
the programme selection button.
3. Press "Start/Pause/Cancel" button to start the
programme.
C
Press "Start/Pause/Cancel" button for 3
seconds to cancel the programme or turn the
programme selection knob in any direction
to end the programme while the machine
is running. Water tank and filter cleaning
warning lights turn on to warn the user when
the programme is cancelled by pressing the
"Start/Pause/Cancel" button for 3 seconds.
However, the warning lights do not turn on
when the programme is cancelled by turning
the programme selection knob. Only the drying
light turns on and the machine remains in hold
until a new programme is selected and the
"Start/Pause/Cancel" button is pressed. Child-
proof lock of the machine should not be active
in order to perform these two operations. If the
child-proof lock is active, deactivate it before
performing these operations.
Adding/removing laundry in standby mode
In order to add or remove laundry after the
programme starts:
1. Press the "Start/Pause/Cancel" button to
switch the dryer to "Pause" mode. Drying
process will stop.
2. Open the door at "Pause" position and close it
again after adding or taking out laundry.
3. Press "Start/Pause/Cancel" button to start the
programme.
C
Any laundry added after the drying process
has started may cause the dried clothes in
the machine intermingle with wet clothes and
the result will be wet laundry after the drying
process is over.
C
Laundry may be added or taken out as much
as desired during a drying process, but this
process will extend the programme duration
and increase energy consumption since
the drying will be interrupted continuously.
Therefore, it is recommended to add laundry
before the drying programme has started.

Child-proof lock

There is a child-proof lock to prevent any
programme interruption due to the pressing of
button while the programme is running. The loading
door and all buttons except the "On/Off" button on
the control panel are deactivated when the child-
proof lock is active.
Press the "Start/Pause/Cancel" and "Cancel audio
warning" buttons simultaneously for 3 seconds to
activate the child-press lock.
To start a new programme after the programme is
over or to interrupt the programme, the child-proof
lock should be deactivated. Press the same buttons
for 3 sec. again to deactivate the child-proof lock.
C
Child-proof lock is deactivated when the
machine is restarted by pressing the On/Off
button.
C
Press the relevant buttons for 3 seconds to
activate the child-proof lock. A long beep
will be heard and the child-proof lock will
be activated. A double beep will be heard if
you press any button or turn the programme
selection knob while the child-proof lock is
active. Press the buttons for 3 seconds to
deactivate the child-proof lock. Single beep
will be heard and child-proof lock will be
deactivated.
A
A double beep will be heard if you turn the
programme selection knob when the machine
is running and the child-proof lock is active.
If you deactivate the child-proof lock without
returning the programme selection knob to
18 EN