Checking The Status Of Your System - Honeywell DOMONIAL User Manual

CHECKING THE STATUS OF YOUR SYSTEM

To check the status of your system, press the control button
All three LEDs light several times in succession, and then the LED for the
current arming status remains lit for 3 seconds.
PERSONAL ATTACK
* This function is optional, and can be set up at installation.
You can call for assistance at any time, even when your system is not armed.
Press buttons 1 and 3 simultaneously for 2 seconds.
Depending on the configuration, the siren may be triggered.
Your alarm company is alerted.
CHANGING THE BATTERY
When the battery starts to run down, instead of remaing fixed, the
LEDs will fade out gradually.
Insert a small screwdriver into the space in the back of the casing,
as shown in the illustration. Push with the screwdriver while
levering upwards, and the front of the casing will release.
Use the screwdriver to push the old battery gently out of its
housing and slide the new battery into place.
To close the casing, insert the lower part of the front into the rear
casing, then slide the upper portion into place and press firmly
until it clicks.
WARNING
There is a risk of explosion if the correct battery is not used. Replace only with
battery type CR2032 (Panasonic or GP).
30
for 1 second.