Honeywell DOMONIAL User Manual page 7

SYSTEM TONES
TOTAL SET
ARMING
PARTIAL SET
ARMING
ANNEX SET
ARMING
EXIT DELAY
ARMING
COMPLETE
ENTRY
DELAY
DISARMING
FAULT
ALERT
* Defined by user during installation
Sequence of 3 modulated sounds
Duration : 4 seconds
Sequence of 2 modulated sounds
Duration : 2,5 seconds
Upon arming ...
one beep per second
After closing the final door
Three fast beeps
Upon entry...
one beep per second
Long and continuous beep
Duration : 2,5 seconds
2 times 7 fast beeps
4 beeps upon alert ...
sent via the keypad
When arming, total set, confirms that the
control panel has received a valid code or
TAG and is preparing to arm total set.
When arming the partial set, confirms that
the control panel has received a valid code
or TAG and is preparing to arm partial set.
Total set arming: beeps continue until final
exit door is closed.
Partial set arming: beeps continue for 30s*
until partial set is armed.
When closing the final exit door, confirms
that the system is armed.
This entry tone sounds for 30 seconds*
after you open the entry door. You should
disarm your system within this time.
When Disarming, confirms that the control
panel has been successfully disarmed.
This signal indicates a fault in the system.
Confirms the transmission of an alert to the
alarm company.
7