Honeywell DOMONIAL User Manual page 21

INFORMATION & MAINTENANCE
CHECKING THE STATUS
Press
Enter your code or touch the Tag Identification area of the keypad with your tag.
The screen displays the following information:
The current arming status
►
The current active icons (whether blinking or steady)
►
Faults affecting the system.
►
To clear memorised faults and reset the system, press
To view any other current faults, press
When all the faults have been viewed, the screen displays "END OF FAULTS". Press
to clear the screen, or it will clear automatically after 20 seconds.
REPLACING THE BATTERY
A blinking battery indicator light informs you that the keypad battery needs to be
replaced.
Remove the keypad from its base
Remove the battery cover by inserting a screwdriver into the slot at
the base of the cover, and levering upwards, as shown in the
diagram.
Replace the battery, respecting the polarities, and secure the cover.
Return the keypad to its base.
WARNING
There is a risk of explosion if incorrect batteries are used. Replace only with a
battery of the same or an equivalent type, recommended by the manufacturer.
Dispose of batteries in accordance with the regulations in force
CLEANING THE KEYPAD
To clean the keypad, use a dry cloth only (no detergent).
again.
21