v Avoid using the projector in dusty environments
v Leave the power cable plugged in (for 2-5 minutes) until the projector returns to room temperature
before placing the projector inside the soft case. Placing the projector into the case too soon after
switching off the power could cause the projector to overheat and will shorten lamp life.
v Be sure to attach the lens cap before placing the projector into the soft case to avoid damaging the lens.
The figures below show the different angles and features of the projector.
Figure 1-2. Front angle of projector
2 OSD buttons
3 Projection lamp cover
4 IR receiver
5 Lens cover
7 Height adjuster
8 Height adjuster button
Downloaded From projector-manual.com Lenovo Manuals
Enlarges the projected image
See following table
Remove when changing lamp
Receiver for IR signal from remote control
Protects the lens
Remove cover, turn lens to focus
Adjusters drop when adjuster buttons are pushed
Push to release height adjuster
Built-in mono speaker
Chapter 1. Product description