Table of Contents
Advertisement
4.3 FACEPLATE INTERFACE
2.
Bend the tab at the center of the tool tail as shown below.
The following procedure describes how to remove the LED labels from the N60 enhanced front panel and insert the custom
labels.
1.
Use the knife to lift the LED label and slide the label tool underneath. Make sure the bent tabs are pointing away from
the relay.
4
2.
Slide the label tool under the LED label until the tabs snap out as shown below. This will attach the label tool to the LED
label.
4-18
N60 Network Stability and Synchrophasor Measurement System
4 HUMAN INTERFACES
GE Multilin
Advertisement
Table of Contents
