Input Key Function - Hubsan X4 Installation Instructions Manual

Attention： After a crash landing, the protection cover will loose and block the
propellers, check and press back the four cover holes before ying again.
9. REMOVING AND INSTALLING LEDS
Removal: Unscrew and remove the lower shell and the rubber feet. Then desolder the red and
yellow wires.
Installation: Solder the red wire onto the anode/positive (+) lead of the LED, and the yellow onto
the cathode/negative (-) lead of the LED. Press the LED wires into the leg slots, then press the
motor wires into the leg slots. Install the lower shell, then the rubber feet. You can determine the
color of the LED lights by looking at the color of the LED wire insulation at the bottom of the LED
lens: red insulation is the red LED, blue insulation is the blue LED.
LED LED
Yellow
LED
LED Red

Input Key Function

>2mm
1. First line up the wires with
the slots. The LED's black
insulated cathode(-) wire
must be outermost.
2. Line up the LED to the round
holder slot. Press the wires
carefully into the slot and secure
them neatly into the arm.
Installation is complete
S/N Mode/ Control
Move the stick forward or backward to increase or decrease speed . Move
MODE 1
(1)
the stick left or right to make the quadcopter roll left or right to initiate
Throttle /Aileron Stick
a banked turn.
Move the stick forward or backward to make the quadcopter nose point
MODE 1
(2)
up or down. Move the stick left or right to make the quadcopter
Elevator/Rudder Stick
yaw left or right.
Move the stick forward or backward to make the quadcopter ascend or
MODE 2
descend. Move the stick left or right to rotate the quadcopter's fuselage
1
Throttle/Rudder Stick
left or right.
Move the stick forward or backward to make the quadcopter move
MODE 2
forward or backward. Move the stick left or right to make the
2
Elevator/Aileron Stick
quadcopter drift sideways left or right.
3 Aileron Trim Aileron trim adjusts for left and right drift.
4 Elevator Trim Elevator trim adjusts for forward and backward drift.
5 Rudder Trim Rudder trim adjusts for drift of left and right rotation or yaw.
6 Throttle Trim Throttle trim normally left at neutral. The lower trim turns LEDs on and o .
7 Power Switch
Push to ON to turn on the transmitter. Push to OFF to turn o .
Function