MasterCraft 55-6883-2 Instruction Manual page 4

13. NEVER LEAVE POWER SWITCH ON WHILE UNATTENDED. Turn the power
switch to OFF. DO NOT leave the toot until it has come to a complete stop.
14. NEVER STAND ON THE TOOL. Serious injury could result if the tool tips or is
accidentally hit. DO NOT store anything above or near the tool.
15. DO NOT OVERREACH. Keep proper footing and balance at alt times. Wear oil-resistant
rubber-soled footwear. Keep the floor clear of oil, scrap and other debris.
16. MAINTAIN TOOLS PROPERLY. ALWAYS keep tools clean and in good working order.
Follow instructions for lubricating and changing accessories.
17. CHECK FOR DAMAGED PARTS. Check moving parts for alignment, jamming,
breakage, improper mounting or any other condition that may affect the tool's
operation. Any part that is damaged should be properly repaired or replaced before use.
18. MAKE THE WORKSHOP CHILDPROOF. Use padlocks, master switches and
ALWAYS remove starter keys.
19. DO NOT operate the tool if you are under the influence of drugs, alcohol or medication
that could affect your ability to use the toot properly.
20. WHEN SERVICING USE ONLY IDENTICAL REPLACEMENT PARTS.
21. DO NOT ALLOW OTHERS TO USE OR OPERATE THIS TABLE SAW UNTIL THEY
HAVE READ AND FULLY UNDERSTOOD THIS INSTRUCTION MANUAL.
WARNING: DUST GENERATED FROM CERTAIN MATERIALS CAN BE
HAZARDOUS TO YOUR HEALTH. ALWAYS OPERATE THE TABLE SAW IN A
WELL-VENTILATED AREA AND PROVIDE FOR PROPER DUST REMOVAL. USE
DUST COLLECTION SYSTEMS WHENEVER POSSIBLE.
_ PR0?'t###_
_jfh _
ALWAYS WEAR EYE PROTECTION.
A table saw can throw foreign objects into your eyes which could
CAUSE permanent eye damage.
ALWAYS wear safety goggles (not glasses). Ordinary eyeglasses
have only impact-resistant lenses...they are NOT safety goggles.
SAVE THESE SAFETY INSTRUCTIONS