Table of Contents
Advertisement
Projector Mode
Precautions when using a projector
Projector
CWhen using a projector to project images, be sure to display the image so that it is centered left-to-right
on the electronic print board screen and with at least a 50 mm (2") gap between the top of the image
and the screen border. Note that the Electronic Pen does not always operate properly when within 50
mm (2") of the top of the screen, 100 mm (3
sides of the screen.
CSince the Electronic Pen position may shift if the image on the screen is trapezoidal, adjust the projector
so that the image on the screen is rectangular.
CWhen projecting an image on the electronic print board using a projector, the image on the screen may
become difficult to see depending on the viewing angle and position due to reflected projector light.
If this happens, adjust the location of the projector or change your viewing position.
CWhen using a projector to project a PC screen, be sure to use optimum resolution settings for the
projector and the PC. The image may be difficult to see if optimum settings are not used. Fine lines in
the image on the electronic print board screen may appear broken particularly if the projector resolution
is lower than the PC resolution.
CWhen using a projector to project images, the Electronic Pen position may shift if the projection position
shifts due to the following causes. If this happens, it becomes necessary to perform calibration to re-
position the projected image on the screen. (For details on calibration, please see page 33.)
When the installed location of the projector is changed.
B
When the position of the electronic print board is changed.
B
When the projection area and position has changed due to using a projector function such as zoom.
B
When the display resolution of the projector or PC has changed.
B
CNote that the position of an electronic print board attached to a stand may shift if it is struck carelessly.
Always make sure the stand's casters are locked in place.
CLight from the projector may enter the eye when using a projector to project images for the purpose of
making presentations and so on. Be very careful as direct projector light may hurt the eyes.
32
Position Receiver
Interactive Upper
Limit Mark
100mm (1
3
/
")
8
35mm
(1
3
/
")
8
Electronic Print Board
Do not use the shaded area.
/
") of the position receiver and 35 mm (1
15
16
Position Receiver
Interactive
Upper Limit Mark
100mm (1
/
")
3
8
35mm
(1
3
/
")
8
Screen Film
/
") from the both
3
8
Hide quick links:
Advertisement
Chapters
Table of Contents
