Panasonic Panaboard KX-BP800 Operating Instructions Manual page 9

CDo not install the unit where it may be exposed to direct sunlight, near heating
Installation
CDo not install the unit in locations having a temperature of 10°C (50°F) or lower or
Screen film CMake thick and dark lines inside the copying
CUse a commercially available white board cleaner for hard-to-erase stains.
CDo not erase with an overly dirty eraser. (See page 65.)
CDo not allow writing to remain on the screen for an extended period of time as it
CPeriodically wipe the screen film gently with a water-dampened cloth that has
CDo not touch the screen, write with markers, or erase while the screen is moving
CUse only the included or designated markers, erasers and thermal transfer film.
Markers,
Erasers and
Thermal
transfer film
CCopy quality increases with the thickness of the drawn line. To ensure quality
CThe markers for interactive (Small) draw thin lines. The quality of the copies may
CDo not store the thermal transfer film in a location subject to extreme changes in
CStore markers horizontally as vertical storage may stop the ink from coming out.
CThe length of one roll of designated thermal transfer film (Replacement film : KX-
SANFORD
equipment, or near air-conditioning vents as this may cause stretching and/or
discoloration of the screen.
where the temperature may change suddenly as this may disable the unit's ability
to make copies.
area. Note that any writing inside the
shaded area on the right figure cannot
be copied.
® ®
(SANFORD EXPO white board cleaner etc.)
will become harder to erase.
been thoroughly wrung. (See page 65.)
as this may result in damage to the unit.
(See page 71.)
Use of accessories other than those included or designated (such as oil-based
markers) may damage the screen or result in hard-to-erase markings.
copies, please use the markers (Big).
be reduced when these markers are used.
temperature (such as near air conditioning or heating equipment) as this may
cause condensation on the thermal transfer film and result in poor print quality
and/or paper jams.
BP081 or KX-BP082) is approximately 100 meters (328.1'). One roll of thermal
transfer film can make approximately 300 sheets of copies.
Note that the total number of copies may differ depending on the operating
conditions.
Also note that the length of the thermal transfer film supplied with the unit is
shorter than the replacement film roll and is only approximately 20 meters (65.6').
® ®
and EXPO are registered trademarks of Sanford corporation.
Precautions
25mm (1")
35mm
Copying area
3
(1 / ")
8
25mm (1")
35mm
3
(1 / ")
8
9