Electrical Connections - Panasonic CQ-VA707N Operating Instructions Manual

Electrical Connections

Cautions:
¡To prevent damage to the unit, be sure to follow the connection diagram as follows.
¡Remove about 5 mm of protective covering from the ends of the leads before connecting.
¡Do not insert the power connector into the unit until the wiring is completed.
¡Be sure to insulate any exposed wires to prevent a possible short-circuit from the car chassis. Bundle
all cables and keep cable terminals free from touching any metal parts.
Basic System
Radio Antenna Connector
Dual CD Changer Control Lead
(Brown w/white stripe)
(White w/black stripe)
(Left)
Front Speaker
Cord
(Gray w/black stripe)
(Right)
(Green w/black stripe)
(Left)
Rear Speaker
Cord
(Violet w/black stripe)
(Right)
Video Control Lead
To the Video Control lead of the
Panasonic car navigation system
(for example, CN-DV2000EN)
Navi Mute Lead
To the Navi Mute lead of the
Panasonic car navigation system
(for example, CN-DV2000EN)
Battery Lead
To the car battery, continuous
+12V DC
Power Lead
To ACC power, +12V DC
Ground Lead
To a clean, bare metallic part of
the car chassis
External Amplifier Control Power
Lead
TV Control Lead
To the power control lead of the
Panasonic TV tuner
❏ Connecting the Power Source
Notes:
¡This monitor system is designed only for use with a 12 volt DC motor vehicle.
¡Be sure to fully plug in the connectors.
¡Route the cord to avoid high-temperature spots and secure with clamps and tape.
¡When game devices are connected, the image may be unstable.
¡When removing the DIN plug, be sure to press the clip.
!2 Power Connector
TWIN CD C-CONT
•
–
FRONT L
(White) +
–
FRONT R
(Gray)
+
–
REAR L
(Green) +
–
REAR R
(Violet)
+
VIDEO-CONT
(Green w/yellow stripe)
NAVI MUTE
BATTERY 10A
(Fuse 10A)
ACC
(Resistor 220Ω)
AMP-CONT MAX0.1A
(Blue w/white stripe)
TV-CONT
(Blue w/red stripe)
Control Unit (Rear)
!6 Ground Lead
To a clean, bare
metallic part of
the car chassis
!6 6 Ground Lead
To a clean, bare
metallic part of
the car chassis
SIDE BRAKE
(Blue w/yellow stripe)
(Orange)
(Yellow)
REVERSE
(Violet w/white stripe)
(Red)
ANT-CONT MAX0.1A
(Black)
(Blue)
ILLUMINATION
(Orange w/white stripe)
!8 8 Display Unit/Control Unit
Connecting Cord
Display Unit (Rear)
!7 Subconnector
Side Brake (Parking Brake)
Connection Lead
Be sure to wire the parking
brake for safety and preventing
accidents. (a page 61)
Reverse Lead
When connecting the rear view
camera, use the reverse lead.
(a page 61)
Antenna Control Lead
To the auto antenna control
power cord of the car
Illumination Lead
To the power line connected to
the side lights of the car
CQ-VA707N
E
N
G
L
I
S
H
52
55