Electrical Connections - Panasonic CX-DVP292U Operating Instructions Manual

Electrical Connections

Basic System Configuration
E
N
Examples of system combination:
G
Color LCD monitor (CY-VMX6800U, option)
L
≥
I
S
H
31
CX-DVP292U (Rear)
R (Red)
Video L (White)
(Yellow)
(Black)
REMOTE IN
AUDIO OUT Not used.
VIDEO OUT DIGITAL OUT
4 Power connector
VIDEO-CONT
(Green/yellow stripe)
PARKING BRAKE
(Blue/yellow stripe)
ACC
(Red)
Resistor (1 k≠)
BATTERY 5A
(Yellow)
Fuse (5 A)
(Black)
40 40
CX-DVP292U
Accessories for Use
No. Item
4
Power Connector
6
Cord Clamp
RCA cord (option)
RCA cord (option)
Attaching the remote
control signal receiver
Double-sided tape
Remote control
signal receiver
When connecting or disconnecting the cord, be
absolutely sure to take hold of the molded part of the
plug (and not the cord itself) and proceed.
Not used.
Side brake (parking brake) connection lead
( page 44)
ACC power lead
To ACC power, +12 V DC.
When connected to the lead colored in dark blue of the
Panasonic CD receiver or having an AUX-IN input terminal,
instead of connecting to the ACC power source, the power of
unit can be linked to that of receiver.
Battery lead
To the battery, continuous +12 V DC.
Connect the battery power cord to a connector that is
always supplied with power from the car battery.
Ground lead
To a clean, bare metallic part of car chassis.
Caution:
This product is designed to operate with a 12 V DC, negative ground battery system.
≥
Q'ty
To prevent damage to the unit, be sure to follow the connection diagram below.
≥
1
Remove approx.
≥
Do not insert the power connector into the unit until the wiring is completed.
≥
1
Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all
≥
cables and keep cable terminals free from touching any metal parts.
Remember, if your car has a drive computer or a navigation computer, the data of its memory may be
≥
erased when the battery terminals are disconnected.
By performing this connection, remote control
signals can be received by the monitor unit.
(Do not connect the remote control signal receiver
when this connection has been performed.)
6 Cord clamp
CY-VMX6800U (option)
1 / z (5 mm) of protective covering from the ends of the leads before connecting.
4
(Black)
Remote control
signal receiver lead
Power socket
Power connector
E
N
G
L
I
S
H
32
Video
(Yellow)
L (White)
R (Red)
R (Red)
L (White)
Video
(Yellow)
VTR1
input lead
41 41
CX-DVP292U