Electrical Connections - Panasonic Strada CN-NVD905U Installation Instructions Manual

Electrical connections

Warning
This product is designed for operation with a negative grounded 12 V DC battery system. Never operate this product with other
battery systems, especially a 24 V DC battery system. If it is used in the wrong type of car, it may cause a fi re or an accident.
 To prevent from damage to the unit, be sure to follow the wiring diagrams below.
 Be sure to fully plug in the connectors. Secure them with clamps and tapes.
 All other installation methods require the use of dedicated metal fi ttings. Consult with a qualifi ed servicing engineer
or your dealer if other methods are required.
When disconnecting a locked cable, press the lock in the arrowed direction while removing the connector.
 Pulling too strongly will break the connector. Check that the lock is disengaged before trying to disconnect the connector.
Power connector
To the vehicle lighting power supply
 Clip connector
Engine control computer unit (ECU)
Battery
Car chassis
How to attach a clip connector
 Insert the cable into
the clip connector.
Vehicle-side wiring cable
Parking brake connection
lead of this unit (Example)
 Press the element
into place.
 Close the cover.
10
10
Vehicle signal connector
 Clip connector
 Speed Pulse Cable (Pink)
This is a circuit protector. Do not cut it off, and be sure to connect it in the
direction of the vehicle speed reading point as is.
 Clip connector
P
R
N
Transmission gear
D
2
L
Side brake (Parking brake) switch
 Clip connector
(Yellow)
(Yellow)
(L) (White)
(R) (Red)
AV connector
 Vehicle signal connector
Illumination lead
(Orange/white stripe)
Vehicle speed signal lead (Pink)
Bundle excess cord. Do not cut it.
Reverse lead (Violet/white stripe)
To the positive (+) lead of the reverse
Reverse lamp
lamp (the lamp with a clear lens that
lights when the transmission gear is
shifted into the reverse position).
Side brake (Parking brake) connection
lead (Bright green)
When the side brake (parking brake) lever is
engaged, the unit is grounded by the chassis.
Car chassis
Video output terminal (VIDEO-OUT)
Connect to a rear monitor.
Video input terminal (AV-IN)
Connect to a VCR, camcorder or TV tuner.
( page 13)
GPS antenna connector
ILLUMINATION
SPEED
REVERSE
SIDE BRAKE
( page 12)
VIDEO-OUT
AV-IN